Geologic Maps
Geologists draw dozens of types of geologic maps. They want to show the
earth as it is deep underground.
The map at the left is called a "structure map". It is drawn on the top of an oil zone that is approximately 8000 feet deep. The map is about two miles across.
The PG picks the top of the oil zone in every well that is drilled. She knows the elevation of the ground at the drilling site. For example, if the elevation of the ground is 1000 feet above sea level, and the top of the oil zone is found at 7700 feet, she subtracts 7700 feet from 1000 feet to get a "subsea" elevation of -6700 feet.
These subsea elevations are posted on the structure map. Then "contour lines" are drawn on the map to create her picture of the underground structure.
In this case, the structure is shaped like a broad dome...or
hill....with the
top of the hill at -6550 feet and the base of the hill at -6800 feet. So, the top of
the hill is about 250 feet higher than the base!
Here is a different type of map called an "isopach (eye-so-pak) map",
constructed over a small gas field. The squares (or "sections")
are one mile in length on each side.
In this map, the petroleum geologist contours the thickness of an individual sandstone. This sandstone is about 45 feet thick in the middle and thins to 20 feet or less around the edges of the gas field.
Below is a colorful map (an isopach, like above) contoured on one of the Springer (Pennsylvanian) sands in Oklahoma. This particular sandstone was deposited in the ocean, as a sand bar. That gave it a lot of porosity, and now it is a pretty nice gas field. The PG made this map by looking at the porosity of the sandstone in the electric logs of all the wells. Then the PG determined how many feet of the sandstone was producible, or "pay". The pay amount is posted in blue alongside the wells.
One more map. This one shows an ancient stream or river channel. The
sandstone is about 30 feet thick in the middle of the channel. Production
charts have been placed on the map. These show graphically how much oil
and gas was produced from each well over the years. The large red numbers
indicate the amount of produced gas. For example, the Soar 1-18 (top
middle) has made 3,267,524 thousand cubic feet of gas, or 3.2 billion cubic feet. That's
a good well !
Amount of Gas Abbbreviation used in the Oil Industry
1000 cubic feet of gas = 1 MCF
1 million cubic feet of gas = 1 MMCF or 1000 MCF
1 billion cubic feet of gas = 1 BCF or 1,000,000 MCF
A typical house might use only about 4 MCF of gas per month for heating. Assuming 6 months of heating per year, that's 24 MCF used per year. That means the Soar has produced enough gas in it's lifetime to heat 136,000 houses for one year !